Tweet
Originally posted by beaverbill
View Post
Bill
-
those are the internal aft butt rib pieces for B model wing. kinda hard to come by. I would gladly accept them for postage.I have two partial ribs, trailing edge, marked 1403-1R and -1L. They don't appear to have ever been installed. I will gladly pass these on to someone who can use them. Maybe a little something for postage, only.
Bill -
-
I want to know when you were on my deck to take that photo on my patio table!
HankComment
-
Yes, but not getting rid of all my T-craft stuff. I have a clipwing I'm going to build, and maybe the YO-57 if I don't sell it. Only selling off the tons of extras I don't need to keep hoarding.Originally posted by astjp2 View PostComment
-
Mike, do you have enough internals to build a pair of wings minus the ribs?N29787
'41 BC12-65Comment
-
Wing hardware? I should depending on which aileron hardware you want. I don't have a complete set of cast hardware anymore.Originally posted by astjp2 View PostComment
-
Prewar stuff is fine, I need the wires/nuts, compression struts, attach fittings, fuel tanks (maybe) aileron attach fittings and maybe 1 bow...I am going to build a new set of wings and then swap them. Spar material so far is the hardest thing to find in a single piece. I am going to build my own ribs, using the same material that they are using on the cubs. I still have to build forms to build the ribs but i now have enough tools to build them. What would you have to get for the parts? TimN29787
'41 BC12-65Comment
-
not much for compression members, wires, etc. I am boxing up a set of disassembled wings now, let me see whats left and will message you.Originally posted by astjp2 View PostComment
Comment