Inside Door Handle

[Scott]

Re: Inside Door Handle

http://1.bp.blogspot.com/-iTV3SqsS4lk/VaqbYJTpGkI/AAAAAAAABjM/3i1o3885R_4/s1600/DSCN3208.JPG

I used a 1/8th punch in my rivet gun to remove the roll pins. Put a tip/shoulder on the punch so it locates accurately in the centre of the roll pin (without expanding it). Once the pins are out, some release oil and heat from a heat gun should get it twisting and then off.

alternatively you can go inside and grind the welds off the end of the shaft, remove the bellcrank and slide the handle and shaft out and deal with the removal on the bench.

[Ragwing nut]

Re: Inside Door Handle

I actually have several, but they are on doors and I have tried just about EVERYTHING to get those off. I am in SE Virginia (A LOOOOONG ways from Petaluma!) but if you could figure a way to get them loose from the shafts there are several people who have told me they want one of mine (I have a stack of doors for post war planes, mostly in bad condition, and the newest plane I have is a 45.
If I could just get ONE off we could make a mold and make new ones. Any ideas?

Hank

Im sure i have a loose one we can do that with.

[Hank Jarrett]

Re: Inside Door Handle

I actually have several, but they are on doors and I have tried just about EVERYTHING to get those off. I am in SE Virginia (A LOOOOONG ways from Petaluma!) but if you could figure a way to get them loose from the shafts there are several people who have told me they want one of mine (I have a stack of doors for post war planes, mostly in bad condition, and the newest plane I have is a 45.
If I could just get ONE off we could make a mold and make new ones. Any ideas?

Hank

[westernhorizon]

Re: Inside Door Handle

Which one?

The top one.

Thanks!

[Hank Jarrett]

Re: Inside Door Handle

Which one?

[westernhorizon]

Looking for an inside door handle for a BC-12D.

Thanks,


Herb
415.771.2555