New Member

[M Towsley]

Re: New Member

Then again, some of us don't. Heheheh.

[crispy critter]

Re: New Member

Hank, I own both....and not a bit ashame to admit it.

[Hank Jarrett]

Re: New Member

EAA is giving away one. I sent in every coupon (OK, honestly, Debbie did. You can read her hand writing and she loves them).

Hank

If you want to get a Cub driver and a Taylorcrafter together, just watch them when a Cessna taxis past. ;-)

[N96337]

Re: New Member

Yes, It was Ray. I paid way too much for the airplane but it was my first and didn't know any better. I broke even when I sold it and had a lot of fun flying it. Your place sounds great. I will have to stop in sometime.

If you bought anything from Ray, you paid too much! haha I used to do a lot of radial engine work for him....usually straightening out what someone else had done for him for free.
Be glad to have ya here...I'm usually not too far away, but also usually on a horse in the summer, so it can take a while to get not too far! Hope to bump into you sometime!
John

[TimHicks]

Re: New Member

Fantastic-looking Luscombe.

[NC36061]

Re: New Member

Hypothetically speaking, what would happen to someone if they showed up to the Montana fly in with a J3?

What is a "J3"?

[astjp2]

Re: New Member

Piper J3 cub, J5 is the cruiser...E2 was the Taylor Cub....predecessor to the J3 and it was redesigned by Piper's engineer named Jamino or something like that....some of the history of our aircraft

[crispy critter]

Re: New Member

Actually you had the E2 followed by the J2 Taylor Cub which became the J3. In short, Taylor actually designed the J3 cub.

[Randy]

Re: New Member

A Montana Fly-in would be fun. Perhaps someplace in the middle of the state with a good restaurant would be a good place to start. Charles

Hypothetically speaking of course......what would happen if an Eastern WA BL-65 showed up at this little Montana Fly-in? I am only in Eastern WA because no one will give me a decent job in Montana.

[N96337]

Re: New Member

You're always welcome over here Randy!
John

[MontanaT-craft]

Re: New Member

I would think everyone would be welcome regardless of their place of origin.
Charles

[Randy]

Re: New Member

You're always welcome over here Randy!
John

Hi John, thought about stopping the last time I went through your area but.................I was driving, a mini van :tdown:

[N96337]

Re: New Member

We even have roads to us, Randy! The minivan will make it just fine and we're usually around here somewhere....this many animals wont let us go too far! Just holler at me and let me know when you'll be headed through and we'll stick a bit closer!
John

[Randy]

Re: New Member

We even have roads to us, Randy! The minivan will make it just fine and we're usually around here somewhere....this many animals wont let us go too far! Just holler at me and let me know when you'll be headed through and we'll stick a bit closer!
John

Dang, roads and everything huh? Montana is getting pretty fancy, next you hear they will be getting lectricity and indoor plumbing

[Randy]

Re: New Member

We even have roads to us, Randy! The minivan will make it just fine and we're usually around here somewhere....this many animals wont let us go too far! Just holler at me and let me know when you'll be headed through and we'll stick a bit closer!
John

Dang, roads and everything huh? Montana is getting pretty fancy, next you hear they will be getting lectricity and indoor plumin