who had the wing wire?

[Jim Herpst]

Go ahead and get a quote, I might be able to be that guy.

Did you recieve confirmation from Mike (would have to be a PM as nothing is here )for contact/confirmation of getting a quote to this company he said he could get to make the wire?

[Ragwing nut]

Did you recieve confirmation from Mike (would have to be a PM as nothing is here )for contact/confirmation of getting a quote to this company he said he could get to make the wire?

I haven't sent sample off yet. I'm looking to see if I have the print for them. I was going to try and reuse the wire that was installed but most of it was cut into a bunch of short pieces. So I will have an airplanes worth of short pieces if anyone needs a piece or three to use on theirs. I will more than likely go the pop rivet route on this one as I don't have time to wait.

[Jim Herpst]

I have the drawing as well. That damed company in Detroit led me around the barn. Let me see where my drawing is. Also have a sample in a tube that Hank sent me or I got when I went to see him a couple of years ago... rleady to ship to the right folks....

[Ragwing nut]

I have the drawing as well. That damed company in Detroit led me around the barn. Let me see where my drawing is. Also have a sample in a tube that Hank sent me or I got when I went to see him a couple of years ago... rleady to ship to the right folks....

send me the drawing when you find it. I found a drawing for aeronca wire, but no tcraft wire so far.

[Jim Herpst]

send me the drawing when you find it. I found a drawing for aeronca wire, but no tcraft wire so far.

I found it. It was Mark J that provided it. Please give me your e mail address and I will send along.I also have samples in a tube ready to ship....That was provided by Hank

[Ragwing nut]

I found it. It was Mark J that provided it. Please give me your e mail address and I will send along.I also have samples in a tube ready to ship....That was provided by Hank

sent

[Jim Herpst]

sent

And drawing sent to your e mail.

[Ragwing nut]

And drawing sent to your e mail.

got it, already forwarded on for quote.

[Jim Herpst]

got it, already forwarded on for quote.

Wonderful. Will assist in marketing this for the greater good...