Baffles

[taylorukuk]

Does anyone have a sketch or drawing of A65 Baffles for a BC12?

[Hank Jarrett]

I had a set of baffles I loaned out to be copied but (surprise surprise) I forgot who I loaned them to! This time I wrote it down AND THEN LOST THE PAPER I WROTE IT DOWN ON!!! I don't need them back yet, but wold like to know who I loaned them to. Also it looks like Ian (taylorukuk) could use a tracing of the parts if he is trying to do the same thing.

Also, I found the rest of the parts I didn't send to whoever I loaned mine to. Glad to add them in if I could remember who I sent them too.

Getting old is hard. Not getting any older is worse!

Hank

[Dick Smith]

Hope this link helps a little bit.

https://www.acornwelding.com/pdf/Other%20Aircraft/Taylorcraft/Taylorcraft%20B-BC12.pdf

[Scott]

As far as I could determine, there are no detailed drawings of the baffles or installation. Needless to say many have been modified over the years too with mixed results.

Mine was a mix of original and non, and I spent a good deal of time figuring out what original was, and mostly stayed true to that, copying the baffles I had that were clearly original, and using craft card and photos to fabricate the rest. I also used silicone seals as the felt ones are inadequate.

I documented the work here

https://c-fclr.blogspot.com/p/firewall-forward.html?m=1

Starts at the bottom, and continues about 1/4 way down the page. The crankcase baffle I made from a photo I got from this site.
S

[taylorukuk]

Thanks everyone - Very useful

[Jim Herpst]

Had mine rebuilt by my metal man per Scott's thoughts. Orginal modified plus fit up to an 0200.. Sots assessment of the orginal felt seals is spot on. Replaced with new style vinyl. 1

[taylorukuk]

Thank you

[PA1195]

You might try these folks in Alaska. They may have some information> https://www.airforms.biz/index.php?r...facturer_id=16

Gary