Fuel shutoff valve connection to cable

[Scott]

https://4.bp.blogspot.com/-bviE79gWPLs/WxI5khfq1sI/AAAAAAAAELg/EkVZgZNhrzQxCwFmenHoXjqZOPhC6K5YgCLcBGAs/s1600/DSCN6719.JPG

This photo shows the psh/pull tube, which is threaded. The knob is attached to a rod which is threaded and forms the male. The nut locks it in place. I think it's 10-32.
S

[Bruce Caldwell]

Thanks Woody! My valve has that pin on it but I didn't know there was a spring. What I'm not sure about is the other end. I don't have the original cable so I'll have to fabricate something. Thanks again!

[Woody]

It is a steel pin brazed on the handle.

[taylorukuk]

IMG_1140.JPGIMG_1141.JPG

[Bruce Caldwell]

To ragwing nut, I'll send you a pm

[Bruce Caldwell]

That helps, but do you have a closer shot of how the rod attaches to the handle? Thanks!!!

[taylorukuk]

This may help IMG_1139.JPGIMG_1138.JPGIMG_1135.JPG

[Woody]

You can fix the internal leak by using fine valve grinding compound and lapping the cone to seat.

[Scott]

For what? no orings were used int he original installation...it was a leather packing..

That's likely why they leaked! The MS29513 (I can never remember the dash number) O ring however fits perfectly and is a good solution to the external leak issue. Internal leaks, a different story.

[Woody]

Drill a 3/16" hole and insert clevis pin. If you want you can braze the pin to handle.

[Bruce Caldwell]

This is for a 46 BC-12D. Thanks for the input so far. I like the threaded shaft but not sure how to attach it to the valve handle.

[Ragwing nut]

its a rod that attaches to a modified valve handle. etuscheon in the panel that it passes through. I have shut off rods if you need one.

[taylorukuk]

Ours has quarter turn restrictor, spring, washer and "o" ring - Same main tank valve as every picture I have seen on this forum!

[astjp2]

Unfortunately this drawing isnt very clear. Just rebuilt our fuel valve and awaiting a new o ring to complete (MS29513 - 011 I think) fuel tank.JPG

For what? no orings were used int he original installation...it was a leather packing..

[Mike S]

Here's the fuel valve end:
thumbnail_IMG_2072.jpgthumbnail_IMG_2075.jpg