As suggested by Mark Bowden the major replacement parts wish list for needed parts is that of the wings. The one will require both front and rear spars and at least half of it's ribs repaired or replaced. This is a pre-war truss 13 rib wing, both wings are original if not to the aircraft at least correct to the aircraft. Any suggestions will be appreciated. The other wing will likely need at least a splicing on the main spar, and half of its ribs repaired or replaced. So both wings it is expected will be complete tear downs and rebuilding. The other major item will be returning an engine into service after 34+ years of storage with only periodic run ups during that period. It went into storage with 166 hours on it since last major overhaul.

You can replace metal truss ribs with stamped if needed, I think I posted my Form 337 on this topic earlier, I can send you a copy if needed.

And you might consider getting a different set of wings that don't need "fixing" (or as much anyway nothings perfect), there is a set on Barnstormers, but no pics or rib count.
This route may be quite a bit cheaper and much less time.

I have a contact that can make you a set of spars if needed.

Thank you. L get back to you in a while on the fellow that can make up spars. If I go tha route it might be better than me trying to do it all myself. I'll check out barnstormer as well.