Control U Joints and sprockets

[Howard Wilson]

Re: Control U Joints and sprockets

I usually have my 'p's after my 'Q's..........

[Larry Lyons]

Re: Control U Joints and sprockets

Sorry to highjack this thread but: TMI about your Ps and/or your Qs! However I just finished my last P so your mileage may vary. :-)
L

[mike lutz]

Re: Control U Joints and sprockets

sprockets and universal,s on e-bay right now(3-7-12).Some one awile back was looking for some.They can be located under aircraft parts and type in Taylorcraft.I know nothing about them.

[swift1b]

Re: Control U Joints and sprockets

Mike

Thank you for getting us back on the universal joints.... However, it was an enlightening discussion.

Thanks to everyone who responded... It was a great help and I now have a universal joint that will get the aileron control free from slack....

regards, bob

[Forrest Barber]

Re: Control U Joints and sprockets

I am back after sonme real problems with other peoples health and this Government crap ..... We are trying to get the big Chesapeake well at the airport . We had to hire a law firm to straighten them up. Could not make Sun-N-Fun , got folks ready to go ; airport dried up , tried to fly WACO 9 last week-end then the rains came again. I WILL be here Tues afternoon, call then or re e-mail. the Universal joints are all about the same a wee bit sloppy. Weld , drill under and ream to bolt size ; Yes i have a lot of sprockets no stop pins installed... try again.