Pulleys

[freightpilot27]

My project came with only a couple pulleys and I don't think they are correct.
Does anyone have the equivalent AN or MS part #'s or the correct dimensions for all the pulleys? Where did everyone get there's?

I see Mcfairlane has a large assortment, but I don't know exactly what’s needed.

I’m considering the BB pulleys, are they worth the extra cost?

Thanks,

[Ron Greene]

Re: Pulleys

Bob,

I copied this from an earlier post I believe.

Ron

After months of work with FAA and vendor delays, the NEW, FAA-PMA ball bearing pulleys for Taylorcraft in the 3.00" and 1.75" sizes are finally ready for shipment on November 11, 2007.

Those wishing some of these parts can obtain them by contacting Classic Aero at 480-650-0883 and providing credit card information or checks for the parts. Pulleys are about $23 each: joy:

Those who placed advance orders for these are thanked for their patience and should contact Doug or Donna with their payment details ASAP.

We do also still stock lining kits that fit the Shinn-Firestone brakes

[PT13Pilot]

Re: Pulleys

Bob,
Run don't walk and order a set of ball bearing pulleys from Doug at the Classic Aero. I just put a set in a BC12 for a customer and we were both estatic with the results. The controls don't feel like sawing through a 2X4 anymore and really made it nicer to fly. They were $420 for all 18, and are worth it. Most off the shelf pulleys you're looking at will have a hole for an AN4 bolt, the T-craft uses an AN3. I flew it about 4 hours while I had it and loved it, and the owner did too. I wouldn't put those old bushing pulleys back in if you had all of them, but that's just me.
CJ

[freightpilot27]

Re: Pulleys

SOLD!

I'll call them to order this week.
Thanks guys,

[astjp2]

Re: Pulleys

Get the yolks tubes rechromed also, I spent $80.00 and it was worth it. Tim