mag timing circuit

[Carl E. Carson]

Re: mag timing circuit

Darryl:

Carl Carson
3013 Tiperary Dr. NE
Cedar Rapids, Ia. 52402

[Marv]

Re: mag timing circuit

Darryl i could use 2. Marvin Post St Rt. 155 SE Corning. Ohio 43730

[flyguy]

Re: mag timing circuit

Shipped PC boards to all you guys this morning. Postal lady says first-class package service because they were light weight.

Cost:
Boards $1.00 each
Bubble-pack $0.50 each
Postage for 1 board $1.64
Postage for 2 boards $1.98

That would total $4.50 for the 2 pack, and a rounded $3.00 for a single. Cash in security envelope is ok with me if it is easier.

Everybody let me know if they arrive OK. I tested each one before packing.
Darryl

[Carl E. Carson]

Re: mag timing circuit

Thanks, I appeciate your efforts. Did I miss your address or I can wait for the pkg. and get it off of it.

Carl

[flylo]

Re: mag timing circuit

Darryl,I PMed you my address. Did you get it & where do I send payment for two? Thanks! Eric

[flybikefarm]

Re: mag timing circuit

I also sent an email couple of days ago. George 1547 East 12th Road Streator, Il. 61364

[flyguy]

Re: mag timing circuit

I sent at least one to everyone that asked.

Darryl Crain
PO Box 1444
Los Banos, CA
93635

[Ron Greene]

Re: mag timing circuit

Darryl,

Mine arrived safely today. $5.00 cash in the mail tomorrow.

Thanks,

Ron Greene

[flylo]

Re: mag timing circuit

Mine arrived today,mailing payment tomorrow.Thanks again!Eric

[flybikefarm]

Re: mag timing circuit

Got mine too. Money on the way. Thanks George

[flyguy]

Re: mag timing circuit

I am all out of boards. Last one ships tomorrow AM.
Darryl

[Larry Lyons]

Re: mag timing circuit

Darryl I got mine over the week end. Your check will go in the mail today or tomorrow. We got another 7" of snow last night!!!!!!!!! We are not used to
this. Thank you very much, however do you have a sketch showing where the wires go? When it come to circuit boards I know enough to cut them out and throw them away but not fix them. LOL Thanks again, Larry

[flyguy]

Re: mag timing circuit

Larry,
Look on the first page of this thread, there is a link with a photo showing the hookup for the ground wire and the one to the P-lead. Second reply from bottom.
I remember us getting about 18" of snow with maybe 4 foot drifts down in Southern Illinois, near Carbondale. It was about 1956, if I remember correctly, LOL. See, Global Warming isn't all bad.
Darryl

[Larry Lyons]

Re: mag timing circuit

Thanks Darryl, sorry I missed that. I try to not make those mistakes.

Larry

[mgold]

Re: mag timing circuit

now that you have sold all your units is possible that you could post the
diagram with parts list so us slow people could build one.
thank you for your time.