If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
converting a Franklin engine to continental 65 on model D Taylorcraft tandom stick controls need a motor mount or drawing to build one contact Ray at 936 760 9428
The D model evolved into the L2, so I suspect the mount would be the same or similar to an L2B mount. The later L2 mounts might work as well. There is probably a drawing on the L2 CD set that was available at one time.
Tweet
Comment