Tweet
I am in need of a nice set of pre war tail surfaces for a restoration we are working on. The ones we have are a little too far gone. Looking for something with very minimal or no repair needed.
Thanks!
Eric
Thanks!
Eric
-
Eric Minnis
Bully Aeroplane Works and Airshows
www.bullyaero.com
Clipwing Tcraft x3
Flying is easy- to go up you pull back, to go down you pull back a little farther. -
Re: Pre War tail surfaces needed
Eric,
I have a STACK of post war tail parts (with the post war rib positions) but need to look for any pre-war ones. They DO fit a pre-war and some are in really good shape if you want to be flying while you look for originals to swap them out. I think one good set are already covered and painted.
Hank -
Re: Pre War tail surfaces needed
Eric -
I've got a prewar three hinge rudder. I was going to chop it up to make it bigger for this clip wing project. If you want to work a trade, or buy this one, let me know!
JimComment
-
Re: Pre War tail surfaces needed
Might be able to work a three way. I have some post war rudders you could rework easily for your project so Eric could get an unmodified pre-war.
HankComment
Comment