Trim Pulley

[Mark Julicher]

Rumored to work on a T-Craft tail, designed to be starter pulleys on a Briggs and Stratton.

PM me if interested.

[Forrest Barber]

Re: Trim Pulley

How much? Ours are still $10.00 .... got about 30 left.

[Mark Julicher]

Re: Trim Pulley

Forrest,
I had these pulleys "in the works" months before I knew you had them... Oh well. Same price as yours. My cost was $10 each, cut out on a water jet and turned on a lathe.

[Forrest Barber]

Re: Trim Pulley

Do they ahve a "V" groove or rounded like the cable?

[Mark Julicher]

Re: Trim Pulley

Do they ahve a "V" groove or rounded like the cable?

I deliberated a long time about the alphabet and what letter would work best. But 26 letters was so very limiting! How is the refined and discriminating T-craft aviator to show the positive qualities of the noble Taylorcraft with only common and mundane letters???

After much soul searching I settled on a capital Lambda and inverted it to correctly grasp the cable.

[Hank Jarrett]

Re: Trim Pulley

Of course since the pulley is round, if the top is a V then the bottom IS a Lambda! Little problem that the pulley is mounted horizontally! Are you sure you didn't cut a > and a < in it?
Hank

Did you use a classic sharp based angle or the more modern flat based one?