Tweet
I was going to toss these but then I thought somebody might be able to use them.
The story is I made them (over the course of several days) and then trimmed off too much material while fitting them to the gear legs (dah). So on my aircraft they end up with a gap of about 5/16 between the two. I was going to just use a piece of baffle material to close the gap but then decided to make two more.
As you can see they've also been trimmed to fit around the struts and the holes are drilled. Not sure if they'll fit any other aircraft based on the Tcraft inconsistencies but if someone wants to try I'll pack them up and ship them.
They are 2024-0 material .032". Quite a bit harder than 0 after forming.
The story is I made them (over the course of several days) and then trimmed off too much material while fitting them to the gear legs (dah). So on my aircraft they end up with a gap of about 5/16 between the two. I was going to just use a piece of baffle material to close the gap but then decided to make two more.
As you can see they've also been trimmed to fit around the struts and the holes are drilled. Not sure if they'll fit any other aircraft based on the Tcraft inconsistencies but if someone wants to try I'll pack them up and ship them.
They are 2024-0 material .032". Quite a bit harder than 0 after forming.
Attached Files
Comment