Tweet
Who is a good source for the trailing edge stock used on a '41?
More cleaning today. I knew the TE had a nice dent in it but didn't now about the horizontal crack about a foot away. The crack is right in the fold. I suppose that I can stop drill and then rivet a piece over the crack but if it is cheap enough and findable then I may just replace the piece. Approximate dimensions are 1 3/8" wide, 9/16" tall at the rib, and 91" long.
The good news is that the more I clean the ribs the better they look. I am using a green scotchbrite pad and MEK and a lot of scrubbing.
Dave
N36078 '41 BC-12-65
More cleaning today. I knew the TE had a nice dent in it but didn't now about the horizontal crack about a foot away. The crack is right in the fold. I suppose that I can stop drill and then rivet a piece over the crack but if it is cheap enough and findable then I may just replace the piece. Approximate dimensions are 1 3/8" wide, 9/16" tall at the rib, and 91" long.
The good news is that the more I clean the ribs the better they look. I am using a green scotchbrite pad and MEK and a lot of scrubbing.
Dave
N36078 '41 BC-12-65
Comment